Round corners with 0.016 in. Radius on one side of washer
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Gaskets, washers and other seals, of vulcanized rubber other than hard rubber
NSN 6105-00-858-4916
NSN 5996-00-887-0595
NSN 5925-01-360-3090
NSN 5895-00-104-8294
NSN 5855-01-201-4857
NSN 5935-00-469-8625
NSN 5950-01-191-4091
NSN 6130-01-561-2100
NSN 5935-01-039-7594
NSN 6150-01-234-2707
NSN 5915-01-089-7930
NSN 5990-01-157-0441