No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 6320-01-227-2648
NSN 5925-01-583-6372
NSN 5920-01-042-1798
NSN 5855-01-178-1130
NSN 6150-00-450-6695
NSN 5965-01-225-7974
NSN 6620-01-023-2938
NSN 5998-01-660-0974
NSN 7035-01-069-3537
NSN 5905-01-619-4711
NSN 6135-01-100-3593
NSN 6685-01-530-3718