Second end has hole 0.310 in. Dia, 1.450 in lg. Drilled into the end of the shaft; a second smaller shaft hangsdown from the second end of the main shaft in the same direction, 0.312 in. Dia, 0.760 in. Lg.
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 5835-00-594-4921
NSN 5935-01-466-9304
NSN 2925-01-514-6301
NSN 5930-01-273-2916
NSN 5895-01-178-5876
NSN 6240-01-457-7490
NSN 5985-01-168-7839
NSN 5985-00-419-0342
NSN 6645-00-664-4665
NSN 5998-01-430-0454
NSN 6320-01-253-9585
NSN 5990-01-354-1366