Second end has hole 0.310 in. Dia, 1.450 in lg. Drilled into the end of the shaft; a second smaller shaft hangsdown from the second end of the main shaft in the same direction, 0.312 in. Dia, 0.760 in. Lg.
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 5905-01-383-7161
NSN 6220-01-158-2871
NSN 6135-01-014-9755
NSN 5835-01-055-2327
NSN 7035-01-612-0088
NSN 6620-01-146-4680
NSN 6650-01-560-2861
NSN 5999-00-758-7833
NSN 2925-01-327-3069
NSN 5910-00-550-1019
NSN 5996-01-069-2915
NSN 5905-01-113-5858