Second end has lh thds
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 7035-00-131-8219
NSN 5945-01-393-6477
NSN 7035-01-463-9855
NSN 6145-01-247-0200
NSN 6220-01-461-2910
NSN 5999-00-584-1867
NSN 6650-01-295-4411
NSN 5985-00-443-5862
NSN 6240-00-580-0666
NSN 5999-01-284-4618
NSN 5975-01-451-4415
NSN 5945-01-087-9133