Second end has lh thds
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 5950-00-849-3684
NSN 6110-01-275-1039
NSN 5965-01-571-4170
NSN 5990-00-548-6163
NSN 6620-01-520-4186
NSN 5950-01-653-6809
NSN 6130-01-443-6655
NSN 5930-01-056-7322
NSN 2925-00-555-4578
NSN 6645-00-134-1531
NSN 2925-01-609-6831
NSN 6130-01-528-1165