A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Gaskets, washers and other seals, of vulcanized rubber other than hard rubber
NSN 6685-01-370-6158
NSN 5915-01-573-5980
NSN 5905-01-386-8246
NSN 6150-01-074-8354
NSN 5915-00-057-8787
NSN 7035-00-020-2227
NSN 5925-00-006-1305
NSN 6135-01-421-1052
NSN 5930-01-253-0488
NSN 6320-01-292-6635
NSN 6650-01-621-1575
NSN 5905-00-123-8462