A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Cotters, cotter-pins, washers and similar articles, of aluminum
NSN 6110-00-146-0037
NSN 5930-00-327-8047
NSN 5895-01-181-7175
NSN 6110-01-089-6260
NSN 6150-00-862-9095
NSN 5998-01-420-2441
NSN 6135-01-437-7741
NSN 6650-01-003-6929
NSN 6650-01-472-0143
NSN 6620-01-093-7592
NSN 6145-01-608-4405
NSN 5950-00-755-2109