Round corners with 0.016 in. Radius on one side of washer
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Gaskets, washers and other seals, of vulcanized rubber other than hard rubber
NSN 6220-00-110-7084
NSN 5945-00-760-1918
NSN 5965-00-196-7320
NSN 6220-01-452-0007
NSN 5855-00-014-5008
NSN 6240-00-398-0740
NSN 5985-01-442-8381
NSN 5910-01-432-2825
NSN 5990-01-024-9659
NSN 6685-01-324-4710
NSN 5920-01-381-3115
NSN 6650-00-927-3391