A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 6150-01-571-8892
NSN 6610-00-096-1682
NSN 5999-01-332-2879
NSN 6620-01-458-8074
NSN 5999-01-414-6963
NSN 6685-00-293-6620
NSN 6645-01-522-5144
NSN 6105-00-553-1941
NSN 5905-01-004-9467
NSN 6220-01-329-3446
NSN 7035-00-849-5526
NSN 6110-01-501-9707