A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 6130-00-062-9921
NSN 6320-00-450-7014
NSN 5915-01-541-3957
NSN 6240-00-334-6766
NSN 5999-01-191-7709
NSN 5965-01-478-9375
NSN 6135-01-322-4655
NSN 5855-00-610-4052
NSN 6130-00-451-3113
NSN 5998-00-457-4656
NSN 6105-01-012-4176
NSN 5998-00-339-9330