A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 5975-01-606-2785
NSN 5920-01-117-6258
NSN 5915-01-448-3510
NSN 5975-00-142-2450
NSN 5925-00-992-3240
NSN 6320-01-141-3791
NSN 5935-00-275-7862
NSN 5915-00-901-4620
NSN 5905-00-253-9993
NSN 5998-01-425-3666
NSN 5945-01-327-4324
NSN 5910-01-017-0680