2 holes through surface; each with a od of 9mm; center to center distance between holes is 24mm.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
NSN 6685-00-504-1911
NSN 5975-00-168-4429
NSN 6220-01-435-6297
NSN 5998-01-533-2832
NSN 5950-00-686-2821
NSN 5930-00-189-0791
NSN 6105-00-426-5430
NSN 5965-01-431-8147
NSN 5915-01-142-1587
NSN 5895-01-254-2012
NSN 5998-00-070-5795
NSN 5985-01-447-5992