2 holes through surface; each with a od of 9mm; center to center distance between holes is 24mm.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
NSN 6150-01-435-4483
NSN 6645-01-268-4045
NSN 6645-00-905-7258
NSN 5835-00-830-6416
NSN 5910-01-173-2812
NSN 5930-01-094-8275
NSN 6650-01-361-9336
NSN 7035-01-576-6029
NSN 5985-00-008-8424
NSN 6685-00-141-4300
NSN 5920-01-632-0074
NSN 6220-00-890-4960