2 holes through surface; each with a od of 9mm; center to center distance between holes is 24mm.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
NSN 6145-01-463-2843
NSN 5855-00-198-3197
NSN 6650-01-166-5025
NSN 6685-01-089-6798
NSN 5855-00-436-3852
NSN 5895-00-263-3983
NSN 5996-00-082-7805
NSN 5855-01-388-2424
NSN 5950-00-406-4277
NSN 5920-00-488-9359
NSN 6650-01-151-3429
NSN 5910-01-352-0918