2 holes through surface; each with a od of 9mm; center to center distance between holes is 24mm.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
NSN 5910-01-361-8864
NSN 6105-01-487-4229
NSN 5998-01-464-9618
NSN 5930-00-832-6939
NSN 6135-00-998-5884
NSN 5960-00-850-1277
NSN 2925-00-147-8150
NSN 5975-01-472-0314
NSN 6610-00-367-9603
NSN 5996-00-201-8861
NSN 2925-01-027-1293
NSN 6645-01-458-3814