A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 5915-01-388-2911
NSN 5960-01-599-9821
NSN 6320-00-433-2773
NSN 6620-01-232-8550
NSN 7035-01-544-0195
NSN 5835-00-262-6146
NSN 6620-01-013-5432
NSN 6110-00-978-8329
NSN 4140-01-360-6744
NSN 6610-01-641-7834
NSN 6320-01-160-7757
NSN 6220-00-189-6561