2 holes through surface; each with a od of 9mm; center to center distance between holes is 24mm.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
NSN 6320-01-108-5933
NSN 7035-01-187-0266
NSN 6105-00-146-1568
NSN 6150-01-631-1857
NSN 6685-01-253-3507
NSN 5935-01-469-1026
NSN 5855-01-222-1242
NSN 6620-00-535-7667
NSN 5895-01-141-6550
NSN 6645-01-247-4549
NSN 5915-00-631-6172
NSN 2925-01-364-7926