A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 5998-01-356-1491
NSN 4140-00-827-1821
NSN 5930-01-363-1075
NSN 5930-00-272-1427
NSN 6610-01-613-1831
NSN 4140-01-341-8265
NSN 6240-01-226-2902
NSN 6240-01-488-7927
NSN 5915-01-027-1407
NSN 5935-01-197-8448
NSN 5925-00-752-8292
NSN 6145-01-491-0033