A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Dept. of the Navy 
Spain 
Republic of Korea 
Italy 
Greece 
Turkey Classification: Copper washers including spring washers not threaded
NSN 6150-01-605-2479
NSN 2925-01-058-1718
NSN 5930-01-256-8862
NSN 5895-01-421-5040
NSN 5945-01-326-2729
NSN 5960-00-011-9315
NSN 6110-01-134-1685
NSN 5895-01-510-3517
NSN 5835-01-529-3050
NSN 5975-01-394-1135
NSN 5910-01-510-4565
NSN 6105-01-276-0997