A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 5855-01-027-1571
NSN 5996-00-645-9957
NSN 5895-01-136-5979
NSN 4140-01-106-4755
NSN 5930-01-512-4645
NSN 5996-01-029-6021
NSN 6135-01-345-6157
NSN 5945-01-160-7894
NSN 5945-01-089-5435
NSN 6620-01-150-9400
NSN 2925-01-459-8093
NSN 6135-01-334-3935