A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Dept. of the Navy 
Spain 
Republic of Korea 
Italy 
Greece 
Turkey Classification: Copper washers including spring washers not threaded
NSN 6145-01-630-1907
NSN 5960-00-262-0345
NSN 6650-01-508-7817
NSN 5960-00-508-1913
NSN 5855-00-237-4088
NSN 5960-01-181-2143
NSN 6685-01-025-7018
NSN 5895-01-523-6614
NSN 5985-00-293-8322
NSN 5835-01-174-7700
NSN 6620-01-204-3181
NSN 5985-01-492-6924