A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 6685-00-823-7790
NSN 5945-01-192-3204
NSN 7035-01-376-3843
NSN 5920-01-381-3115
NSN 5895-00-548-9329
NSN 5905-00-470-1652
NSN 4140-00-797-7765
NSN 4140-01-581-4404
NSN 5975-00-001-9329
NSN 6645-01-601-5473
NSN 6130-01-114-7375
NSN 6650-01-578-4212