A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 6130-00-205-1714
NSN 5965-01-190-7391
NSN 5835-01-116-2369
NSN 5835-01-424-4577
NSN 6105-00-420-2335
NSN 5930-01-441-3053
NSN 2925-01-025-0082
NSN 5996-01-343-0154
NSN 6610-01-011-0296
NSN 5965-01-512-9925
NSN 5930-01-418-6903
NSN 4140-01-049-3977