A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Dept. of the Navy 
Spain 
Republic of Korea 
Italy 
Greece 
Turkey Classification: Copper washers including spring washers not threaded
NSN 6645-00-103-2517
NSN 5950-01-211-7018
NSN 5930-01-064-1263
NSN 5835-00-238-1516
NSN 5996-01-098-9101
NSN 5975-01-416-9385
NSN 2925-01-656-8217
NSN 5960-01-461-9284
NSN 5915-01-512-8026
NSN 4140-01-571-9794
NSN 5895-01-423-2773
NSN 5990-01-013-8464