A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Dept. of the Navy 
Spain 
Republic of Korea 
Italy 
Greece 
Turkey Classification: Copper washers including spring washers not threaded
NSN 5895-00-967-8253
NSN 5935-01-627-4660
NSN 6130-01-539-2157
NSN 6685-01-013-8915
NSN 6620-01-492-8470
NSN 5999-01-197-6952
NSN 5960-01-573-6483
NSN 5905-01-485-5103
NSN 6650-01-598-2655
NSN 6320-01-449-1014
NSN 5960-01-415-3574
NSN 6110-01-564-0790