A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Dept. of the Navy 
Spain 
Republic of Korea 
Italy 
Greece 
Turkey Classification: Copper washers including spring washers not threaded
NSN 6240-01-029-8734
NSN 5985-01-529-5582
NSN 6645-01-335-9183
NSN 6130-01-435-9241
NSN 2925-01-274-8576
NSN 5950-01-434-8835
NSN 6320-01-441-2438
NSN 6135-00-935-5241
NSN 5920-01-329-4571
NSN 6240-01-446-2503
NSN 6620-01-430-2212
NSN 6150-01-365-9597