A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 5975-00-262-0896
NSN 6150-01-330-7289
NSN 5996-01-198-4583
NSN 5920-01-397-8380
NSN 5998-01-465-2736
NSN 5960-01-241-9078
NSN 5855-01-179-8887
NSN 5975-01-553-0915
NSN 5910-01-032-4190
NSN 5975-01-227-6306
NSN 6620-01-072-9372
NSN 5895-01-103-0249