A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 5990-01-529-7307
NSN 5910-00-607-1416
NSN 5985-00-825-4777
NSN 5999-01-482-8963
NSN 6650-01-384-7867
NSN 6130-01-639-8149
NSN 5950-01-476-7887
NSN 6320-01-576-6310
NSN 6685-01-327-3195
NSN 5835-01-544-5183
NSN 5915-01-429-3738
NSN 5835-01-580-0446