A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 5985-00-368-7198
NSN 5996-00-497-3809
NSN 2925-01-218-5556
NSN 5910-01-116-3574
NSN 6645-01-449-8752
NSN 6620-00-829-1860
NSN 5950-00-163-3597
NSN 5975-01-207-0508
NSN 5975-00-900-9730
NSN 5990-01-542-4212
NSN 6620-01-595-7459
NSN 6105-01-439-8420