A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Dept. of the Navy 
Spain 
Republic of Korea 
Italy 
Greece 
Turkey Classification: Copper washers including spring washers not threaded
NSN 6150-01-216-3166
NSN 5990-01-476-8813
NSN 7035-01-649-4042
NSN 5975-01-550-2237
NSN 5910-01-555-8811
NSN 5920-01-599-5458
NSN 7035-01-189-7367
NSN 5999-01-628-6732
NSN 6135-00-962-4111
NSN 5935-01-562-7056
NSN 2925-01-600-2309
NSN 6220-01-401-5337