A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Dept. of the Navy 
Spain 
Republic of Korea 
Italy 
Greece 
Turkey Classification: Copper washers including spring washers not threaded
NSN 6650-01-633-9147
NSN 5950-01-040-2776
NSN 6150-01-062-2162
NSN 6645-01-146-9158
NSN 6620-01-132-9678
NSN 5835-01-606-8768
NSN 6110-01-439-4520
NSN 5996-00-205-2933
NSN 6685-01-211-2141
NSN 5930-01-482-0119
NSN 6645-01-227-2036
NSN 4140-00-248-6089