Hollow shaft, 1.312 in. Bore dia; 2nd end keyway is 180 degrees from cross drilled hole
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 6130-00-933-9081
NSN 5985-01-330-0242
NSN 6105-01-481-0322
NSN 5990-01-452-0911
NSN 5990-01-468-1292
NSN 6135-01-071-4923
NSN 6135-01-100-3593
NSN 5835-01-502-9228
NSN 6610-01-103-4627
NSN 4140-00-045-8117
NSN 7035-01-633-9537
NSN 4140-01-428-7318