Hollow shaft, 1.312 in. Bore dia; 2nd end keyway is 180 degrees from cross drilled hole
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 6240-00-949-4849
NSN 6150-01-145-2660
NSN 6320-00-433-2773
NSN 4140-01-308-9649
NSN 5925-00-588-2519
NSN 5998-01-117-4621
NSN 2925-01-062-2660
NSN 6685-01-381-0759
NSN 5895-01-076-4204
NSN 5999-01-467-0774
NSN 5920-01-442-6756
NSN 6110-00-659-3348