Hollow shaft, 1.312 in. Bore dia; 2nd end keyway is 180 degrees from cross drilled hole
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 5990-01-139-6042
NSN 5930-01-328-7970
NSN 5975-01-282-7194
NSN 5935-01-607-7280
NSN 6320-00-164-4087
NSN 5905-01-328-1205
NSN 5935-01-323-5804
NSN 5905-00-200-1402
NSN 6620-01-559-1921
NSN 6110-01-191-7742
NSN 6645-00-063-1996
NSN 5855-01-609-9767