Hollow shaft, 1.312 in. Bore dia; 2nd end keyway is 180 degrees from cross drilled hole
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 6145-01-488-5114
NSN 6645-00-950-3418
NSN 5945-01-212-2691
NSN 7035-01-132-7209
NSN 5910-01-429-2992
NSN 6105-01-632-9617
NSN 4140-01-605-5652
NSN 7035-00-111-4389
NSN 5905-01-168-8793
NSN 5965-01-032-0940
NSN 5996-00-466-9781
NSN 6645-01-633-1852