Hollow shaft, 1.312 in. Bore dia; 2nd end keyway is 180 degrees from cross drilled hole
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 6150-01-130-5212
NSN 5905-01-431-2094
NSN 6130-01-650-8132
NSN 5996-01-410-6984
NSN 5985-01-120-7821
NSN 5999-01-149-2476
NSN 5855-01-147-4785
NSN 6685-00-606-3348
NSN 7035-01-044-0136
NSN 5835-00-247-0161
NSN 6320-01-177-3192
NSN 6685-01-252-9470