Hollow shaft, 1.312 in. Bore dia; 2nd end keyway is 180 degrees from cross drilled hole
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 5915-01-023-8930
NSN 5905-01-395-5303
NSN 6130-01-457-4896
NSN 6220-01-205-3320
NSN 7035-01-008-7248
NSN 5920-00-699-1927
NSN 4140-00-455-3170
NSN 6240-00-311-6180
NSN 6685-00-270-8070
NSN 5855-00-427-7848
NSN 7035-01-194-9482
NSN 5915-01-551-0745