Hollow shaft, 1.312 in. Bore dia; 2nd end keyway is 180 degrees from cross drilled hole
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 5935-01-249-9700
NSN 6130-01-040-9000
NSN 6105-00-683-5459
NSN 5905-00-233-0857
NSN 5950-01-599-8137
NSN 5960-01-338-3412
NSN 5975-01-248-8740
NSN 6145-01-605-3228
NSN 5990-01-087-3103
NSN 6645-01-320-2661
NSN 6105-01-388-1926
NSN 6220-01-054-9112