Hollow shaft, 1.312 in. Bore dia; 2nd end keyway is 180 degrees from cross drilled hole
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 6135-00-145-8884
NSN 5950-00-455-2054
NSN 5920-01-426-8517
NSN 5945-01-466-8133
NSN 5965-01-152-7606
NSN 5920-00-263-2192
NSN 6130-00-756-4271
NSN 6130-01-088-6693
NSN 5910-01-542-2437
NSN 6220-01-634-0660
NSN 6650-01-295-6059
NSN 6645-00-664-4665