Hollow shaft, 1.312 in. Bore dia; 2nd end keyway is 180 degrees from cross drilled hole
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 5985-01-639-8150
NSN 5935-00-276-9413
NSN 5965-01-505-9989
NSN 6110-00-422-4973
NSN 6610-01-468-0679
NSN 5895-01-484-9069
NSN 4140-00-990-8389
NSN 6685-01-010-3176
NSN 5996-01-646-1264
NSN 5935-01-446-6396
NSN 7035-00-270-5519
NSN 6685-00-400-6682