Hollow shaft, 1.312 in. Bore dia; 2nd end keyway is 180 degrees from cross drilled hole
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 5925-00-246-4645
NSN 6645-00-739-6718
NSN 2925-00-986-8393
NSN 5925-01-381-2528
NSN 5905-00-922-9283
NSN 5930-01-423-1674
NSN 6145-01-467-8604
NSN 5975-01-374-4572
NSN 5915-01-633-9845
NSN 6135-01-622-1296
NSN 5895-01-053-6273
NSN 6610-00-816-4998