Hollow shaft, 1.312 in. Bore dia; 2nd end keyway is 180 degrees from cross drilled hole
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 6650-00-089-9423
NSN 6610-01-523-8547
NSN 5960-01-174-6975
NSN 5895-00-126-2621
NSN 5999-01-510-4358
NSN 6240-01-190-9523
NSN 6610-01-229-3679
NSN 5950-00-103-6456
NSN 5996-01-577-9696
NSN 7035-01-432-2424
NSN 4140-01-435-5412
NSN 5915-01-447-4515