Hollow shaft, 1.312 in. Bore dia; 2nd end keyway is 180 degrees from cross drilled hole
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 4140-01-527-9577
NSN 6145-01-125-0974
NSN 5960-01-411-5899
NSN 5910-00-155-8775
NSN 5960-01-552-8601
NSN 5895-01-232-7367
NSN 6135-00-548-2765
NSN 5990-01-276-3686
NSN 5895-01-063-7400
NSN 7035-01-068-1096
NSN 2925-01-394-5650
NSN 5910-00-479-0347