Hollow shaft, 1.312 in. Bore dia; 2nd end keyway is 180 degrees from cross drilled hole
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 5910-01-344-5553
NSN 5835-01-055-6859
NSN 5915-00-670-7948
NSN 5945-00-106-2237
NSN 6145-01-300-6014
NSN 5895-01-292-0948
NSN 5960-00-055-8010
NSN 5895-01-307-5491
NSN 5985-01-390-6297
NSN 6650-01-111-6825
NSN 5965-00-393-1294
NSN 5990-01-300-7801