Hollow shaft, 1.312 in. Bore dia; 2nd end keyway is 180 degrees from cross drilled hole
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 6685-00-228-6983
NSN 5996-00-648-6580
NSN 2925-01-143-0092
NSN 5990-01-145-2878
NSN 5925-01-421-2632
NSN 6135-01-581-8163
NSN 5915-01-241-9336
NSN 6130-00-866-3469
NSN 6110-01-333-7923
NSN 6610-01-062-5178
NSN 6220-00-284-3220
NSN 5855-01-222-1242