Hollow shaft, 1.312 in. Bore dia; 2nd end keyway is 180 degrees from cross drilled hole
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 5915-01-249-5908
NSN 6135-01-658-3265
NSN 6610-01-122-0064
NSN 6620-00-137-0332
NSN 5835-00-153-4100
NSN 5915-00-359-7776
NSN 5855-01-225-5855
NSN 5835-01-462-5983
NSN 6110-01-178-7833
NSN 5930-00-839-6081
NSN 5999-01-502-7101
NSN 5975-00-618-0161