Hollow shaft, 1.312 in. Bore dia; 2nd end keyway is 180 degrees from cross drilled hole
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 6610-01-624-2561
NSN 5998-00-393-4753
NSN 7035-01-433-3547
NSN 5835-00-356-3825
NSN 6620-01-435-7083
NSN 6150-00-451-9869
NSN 6650-00-150-6885
NSN 5985-00-572-8585
NSN 5905-01-004-9255
NSN 5920-01-540-8043
NSN 5935-00-338-4877
NSN 5895-01-197-1847