Hollow shaft, 1.312 in. Bore dia; 2nd end keyway is 180 degrees from cross drilled hole
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 5985-01-491-8961
NSN 5945-01-020-7897
NSN 6220-01-092-8959
NSN 6135-00-643-4843
NSN 6220-01-642-1660
NSN 6685-00-173-3848
NSN 5930-01-252-4448
NSN 5855-00-821-7512
NSN 6645-00-542-1206
NSN 5990-01-008-9900
NSN 6610-00-361-6954
NSN 5905-01-500-4400