Hollow shaft, 1.312 in. Bore dia; 2nd end keyway is 180 degrees from cross drilled hole
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 6130-01-654-3494
NSN 6240-00-952-1906
NSN 5998-01-352-5411
NSN 6130-01-639-8149
NSN 6135-00-009-4100
NSN 6135-00-351-8606
NSN 6135-00-880-1026
NSN 6105-01-433-2204
NSN 5920-00-232-6419
NSN 6105-01-233-6585
NSN 6620-00-342-9843
NSN 5996-00-534-1894